Using Moleskin to Stop Balls from Slipping Out of Chastity Devices

Sure thing. I’m relatively fresh to the world of chastity devices, but I think I’ve stumbled upon a simple remedy for an issue that seems pretty widespread.

Recently, we experimented with several models: the CB 3000, the CB 6000, the CB 6000s, and currently, the compact Holy Trainer fitted with a 36mm ring. In every instance, even when using the tiniest rings and pins, my testicles would slide out of place, causing the whole contraption to drop off. (Side note: I’ve accepted that I have unusually small balls.). It looked like getting a Prince Albert piercing was the only way forward, but my wife wasn’t keen on having her little weenis pierced.

The answer is here… and it’s effective. MOLESKIN!!! I adhered a strip of moleskin to the inner side of the tube and wrapped another piece around the sides and bottom edge of the ring. This material creates a smooth, comfortable layer against my scrotum while providing enough grip to keep my balls from sliding through the gap.

Previously, they would slip out two or three times daily. Now, I’m on day three of non-stop 24-hour locking with zero slips. It’s been so successful that we’ve advanced to phase two. There is no emergency key available; she holds total authority. To keep the moleskin intact, she removes it while I shower. It might not be strictly required, but when she decides to do it, who am I to complain? After all, it’s her little weenis.