Balls that keep escaping

I recently picked up a new solid ring for my A086.

I owned a 50mm, a 47mm, and a 41mm. The 50mm was too loose. The 47mm worked okay but it was really hard to get my balls through at just the right tightness. The 41mm looked small—that’s 1 5/8” according to maturemetal.

I tried the 47mm, but in less than 24 hours I had escaped, so I switched to the 41mm. It was very snug (NO WIGGLE ROOM) and within two hours my right ball pulled hard and finally slipped out, leaving one ball and my penis trapped.

This has happened with every device and ring regardless of whether there is a gap between the ring and cage or not. My Cb6ks pins actually broke off due to the tightness. I’ve tried nearly all techniques and concluded that I can escape any ring, even if it’s too small.